Klein Tools CL800 Manuel D'instructions page 10

ENGLISH
AC/DC CURRENT (LESS THAN 600A)
AC Current is measured by pressing the clamp trigger
the clamp and placing it around a current-carrying wire. When
3
measuring, care should be taken to ensure that the clamp
completely closed with trigger
passes perpendicularly through the center of the clamp
with the arrow markings with the arrow markings
To measure current:
1. Rotate the Function Selector switch
setting.
NOTE: The meter defaults to AC measurement. Press the "SEL"
button to toggle between AC and DC modes. The AC or DC icon
9
on the LCD indicates which mode is selected.
2. Place clamp
polarity markings
avoid negative readings. The current measurement will be shown in
the display. The meter will auto-range to display the measurement in
the most appropriate range.
Disconnect test leads when measuring with the clamp.
NOTE: If non-zero values are displayed prior to measuring in DC
current mode, an offset correction is required. With meter in DC
current mode, press and hold the "SEL" button
DC current ZERO function. Subsequent DC current measurements
automatically subtract the offset correction for improved accuracy.
10
OPERATING INSTRUCTIONS
. .
11 11 11
around wire. When measuring DC current, align the
3
on the clamp with the polarity of the wire to
15
fully released, and that the wire
10
to the AC/DC current A
2
to open
10
is
3
in line
3
to activate the
9