ResMed AirFit F20 Mode D'emploi page 13

Weekly:
1. Disassemble the mask. The magnets can remain attached to the
headgear during cleaning.
2. Handwash the headgear in warm water with mild liquid detergent.
3. Rinse the headgear under running water. Inspect to ensure the
headgear is clean and detergent free. Wash and rinse again, if
necessary.
4. Squeeze the headgear to remove excess water.
5. Leave the headgear to air dry out of direct sunlight.
Cleaning your mask at home (AirTouch F20)
Handwash the elbow, frame and headgear (not the cushion) by gently
rubbing in warm (approximately 86°F/30°C) water using mild liquid
detergent. Rinse them well under running water and allow to air dry out
of direct sunlight.
If required, it is recommended to wipe the cushion using CPAP wipes or
equivalent and allow to dry. It is recommended to replace your cushion
every month.
WARNING
• As part of good hygiene, always follow cleaning instructions
(using mild liquid detergent for recommended components and if
required, wiping the cushion with CPAP wipes or equivalent).
Some cleaning products may damage the mask, its parts and their
function, or leave harmful residual vapors that could be inhaled if
not rinsed thoroughly.
• Regularly clean your mask and its components to maintain the
quality of your mask and to prevent the growth of germs that can
adversely affect your health.
CAUTION
• Visible criteria for product inspection: If any visible deterioration
of a system component is apparent (cracking, discoloration, tears,
etc.), the component should be discarded and replaced.
• The cushion must not be submerged in liquid as this may damage
the cushion and affect mask performance.
• Discard the cushion if it is submerged in liquid or heavily soiled.
English 7