Emerson MIDWAY ECO LED Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
Align the clevis pin holes in the downrod with the holes in
the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 4).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor coupler
is properly installed and securely tightened.
3.5
While pulling up on the downrod, securely tighten the two
Phillips head set screws in the motor coupler (Figure 5).
NOTE: The set screw must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the clevis pin and set screws in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and set screws are properly
installed could result in the fan falling.
3.6
Remove and retain the three #8-32 x .75" flat head screws
pre-installed on top of the fan assembly. (Figure 6).
(Continued)
DOWNROD
CLEVIS
PIN
MOTOR
COUPLING
Figure 4
DOWNROD
MOTOR
COUPLER
Figure 5
Figure 6
6
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
RETIGHTEN
SET SCREWS
DOWNROD
#8-32 x .75" FLAT
HEAD SCREWS (3)
FAN ASSEMBLY
ETL Model No.: CF955L