Table Des Matières; Safety Instructions - Emerson MIDWAY ECO LED Mode D'emploi

Section
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
1. Unpacking Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
2. Electrical Requirements
3. Ceiling Fan Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-11
4. How to Hang Your Ceiling Fan . . . . . . . . . . . . . . . . . . . .11-12
5. How to Wire Your Ceiling Fan . . . . . . . . . . . . . . . . . . . . .13-14
6. Final Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
7. Remote Control Procedures . . . . . . . . . . . . . . . . . . . . . . .16-18
8. Programming the Receiver Operating Frequency &
High Speed Conditioning of Fan Control . . . . . . . . . . . . . . . .19
READ AND SAVE THESE INSTRUCTIONS
WARNING
!
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a. Use this unit only in a manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
b. Before servicing or cleaning unit, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a warning device,
such as a tag, to the service panel.
1. Read your owner's manual carefully and keep it for future
reference.
2. Be careful of the fan and blades when cleaning, painting,
or working near the fan. Always turn off the power to the
ceiling fan before servicing.
3. Do not put anything into the fan blades while they are
turning.
4. Do not operate reversing switch until fan blades have
come to a complete stop.
Additional Safety Instructions for Installation
1. To avoid possible shock, be sure electricity is turned off
at the fuse box before wiring, and do not operate fan
without blades.
2. All wiring must be in accordance with the National
Electrical Code "ANSI/NFPA 70-2014" and Local
Electrical Codes. Use the National Electrical Code if
Local Codes do not exist. The ceiling fan must be
grounded as a precaution against possible electrical
shock. Electrical installation should be made or
approved by a licensed electrician.
3. The outlet box and joist must be securely mounted and
capable of reliably supporting at least 50 pounds. Use
only U.L. outlet boxes listed as "Acceptable for Fan
Support of 22.7kg. (50 lbs.) or less", and use the
Table of Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Safety Instructions

Page ection
S
9. Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
10. Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
11. Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
12. Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22-23
13. Energy Efficient Use of Ceiling Fans . . . . . . . . . . . . . . . . . .24
Ceiling Fan Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . .25
Spanish . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
French . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .53
mounting screws provided with the outlet box.
Most outlet boxes commonly used for support of light
fixtures are not acceptable for fan support and may need
to be replaced. Consult a qualified electrician if in doubt.
4. The downrod furnished with the fan provides the
minimum recommended floor to fan blade clearance for a
8 foot ceiling.
5. The fan must be mounted with the fan blades at least
7 feet from the floor to prevent accidental contact with
the fan blades.
6. Follow the recommended instructions for the proper
method of wiring your ceiling fan. If you do not know
enough about electrical wiring, have your fan installed by
a licensed electrician.
NOTE: This fan is suitable for use with solid-state speed
controls.
NOTE: All set screws must be checked and re-tightened
where necessary before installation.
To reduce the risk of electrical shock, this fan must be
installed with an isolating wall control/switch.
To reduce the risk of fire or electrical shock, this fan
should only be used with fan speed control, Model No.
RH-786R, manufactured by Rhine Electric Co., Ltd.
To avoid fire, shock or injury, do not use an Emerson or
any other brand of control not specifically approved for
this fan.
This product is designed to use only those parts supplied
with this product and/or any accessories designated
specifically for use this product by Emerson Electric Co.
Substitution of parts or accessories not designated for
use with this product by Emerson could result in
personal injury or property damage.
To reduce the risk of personal injury, do not bend the
blades during installation, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
rotating fan blades.
2
WARNING
!
ETL Model No.: CF955L
Page