Emerson MIDWAY ECO LED Mode D'emploi page 11

3. Ceiling Fan Assembly
3.16
Rotate the LED light fixture clockwise to engage the key
hole slots onto the two #8-32 x .375" pan head screws
(Figure 16).
Secure the LED light fixture assembly by tightening the two
#8-32 x .375" pan head screws.
Reinstall and tighten the previously removed #8-32 x .375"
pan head screw.
A spare #8-32 x .375" pan head screw is supplied in the
loose parts bag, if required.
You have now completed the initial assembly of your new
ceiling fan. You can now proceed with hanging and wiring
your fan.
Please call Emerson
1-800-654-3545 if you
about installation and operation of this ceiling fan.
WARNING
!
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 17).
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
technical support at
have any questions
(Continued)
REINSTALL ONE
#8-32 x .375"
PAN HEAD SCREW
LED LIGHT
FIXTURE
LOWER
HOUSING
Figure 16
AT LEAST
7'
Figure 17
11
RETIGHTEN
TWO
#8-32 x .375"
PAN HEAD
SCREWS
CEILING
FLOOR
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF955L