Jacuzzi Fuzion 35x70 Directives D'installation Et D'utilisation page 17

Luxury Whirlpool Bath
Decrease Speed
Press the (-) button to decrease whirlpool speed.
There are 2 whirlpool motor speeds, high and low. The
indicator lights display the setting.
•
1 light on = Low speed
•
4 lights on = High speed
Increase Speed
Press the (+) button to increase whirlpool speed.
There are 2 whirlpool motor speeds, high and low. The
indicator lights display the setting.
•
1 light on = Low speed
•
4 lights on = High speed
Air Flow
Press the left air valve button to active the left air valves,
press the right air valve button to activate the right air
valves.
The amount of air induced into the whirlpool jets can be
controlled from maximum to none. Use the (+) and (-)
buttons to increase or decrease air flow.
The indicator lights immediately to the left and right of the air
valve buttons indicate the amount of air induced.
Wave Mode
Press the wave button to cycle the air flow in the jets
from maximum to no air flow.
If the wave mode does not initiate, ensure that you are
in whirlpool operation mode (lights immediately to the
left of the jet button should be brightly lit).
Both right and left air valves are cycled simultaneously
from a closed position (no air) to open (max air).
The indicator lights will display the flow as it cycles from
minimum to maximum. To turn off wave mode, press the
(wave) button.
Installation and Operation
Low
Low
www.jacuzzi.com
High
High
Left Right
Page 17