Removing The Refrigerator Doors; Required Tools - Samsung RF263TE Serie Manuel D'utilisation

FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 335lbs (152kg).
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.

REQUIRED TOOLS

Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade screw
screwdriver(+) driver(-)
Allen wrench
(3/16") (5mm)
DA68-02601A(EN+FR+ES)-0.2.indb 7
REMOVING THE REFRIGERATOR
DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
Use care when you remove the doors/drawer. The
doors are heavy and you could injure yourself.
Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- W asting energy due to improper door seal.
HOW TO ASSEMBLE THE HANDLE
Orient each handle so that the end with the sticker
attached is at the top and the holes with the
tightening screws are facing each other.
Then, follow the directions below to install each
handle.
Socket wrench
(10mm)
By using Phillips screwdriver, fix the screw
(optional) and then put the handle on the
Be careful not to drop, damage or scratch
the door/drawer while removing them.
setting up _09
2012.3.31 9:49:32 AM