Installing The Water Dispenser Line - Samsung RF263TE Serie Manuel D'utilisation

. 1 Pull out the freezer drawer
see the lower hinge
2
2. Insert a philips screwdriver (+)
of the lower hinge.
4
3. Adjust the height by turning a philips
screwdriver (+) clockwise (
3
counterclockwise (
UP
When you turn a philips screwdriver (+)
counterclockwise (
move up.
2
4
1
3
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20~125psi (138~862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
DA68-02601A(EN+FR+ES)-0.2.indb 10
,then you can After you have connected the water line, make
1
. sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
into the shaft
3 dispenser lever until the water runs from the water
outlet.
) or
DOWN
).
), the door will
UP
Connecting to the water supply line
1.
2.
3
3.
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.
supply.
Locate the nearest cold water drinking line and
Cold water line
Pipe clamp
Shut off valve
Connect the water line installation kit to the
Cold water line
Pipe clamp
Shut off valve
Use Copper Tubing Use Plastic Tubing
¼" copper tubing
¼" compression nut (1pc)
Ferrule (2pc)
Water line installation kit
¼" plastic tubing
Molded end(Bulb)
¼" compression nut (1pc)
13_ setting up
2012.3.31 9:49:43 AM