Samsung RF263TE Serie Manuel D'utilisation page 20

To remove the ice cubes without use the
WARNNIG
(Remove the front cover of the Ice Maker)
Ice cubes in the ice machine may leak on
the drawer.
Not put food into the tray of ice.de hielo.
If you store food in the ice bucket,may hinder the
WARNNIG
ice maker to open or close the door, and damage
the ice maker.
Note that the ice cubes from the ice bucket
can spill over the box to remove the tray from
WARNNIG
the drawer. In this case, you must remove the
drawer the ice cubes that have been spilled.
In case of power outage, ice cubes can melt
and then freeze when power returns, causing
WARNNIG
the dispenser to stop working.
To prevent this from happening after a power outage,
remove the ice bucket and discard the ice and
wastewater.
If you use all the ice at one time, repeat
Steps 2 and 3 on the previous page.
However, wait only 8 hours before removing the
cubes and ensure their maximum output.
may have bad taste.
How to Use Ice O function
20_ operating
DA68-02601A(EN+FR+ES)-0.2.indb 16
check the
water level
Test button
remove all ice cube tray. If not using the ice
dispenser, it is possible to stack the cubes.
Remove the tank in the direction of the arrow.
Dispose of ice cubes or ice mass. Push the bottom
of the tray until it clicks.
Use only the ice maker refrigerator. Only a suitably
WARNNIG
supply to the refrigerator. Connect only to a
potable water supply.
In order that the ice maker work properly, need a
water pressure of 20 ~ 125 psi (138 ~ 862 kPa).
Whether traveling for vacation or business and
will not use water dispensers and ice for an
extended period:
- Close the stopcock. If not, can result in water
leakage.
- Remove all food.
- Unplug the refrigerator.
- Remove excess moisture from inside the
refrigerator and leave doors open. Otherwise,
hands or any other inappropriate object in the
container or bucket of ice maker.
It may cause personal injury or property damage.
-
Can cause injury.
Never try to take the ice maker.
-
Do not wipe or spray the ice tray with water while
in the refrigerator. Remove for cleaning.
When inserting the tray of the ice maker,
make sure it is well centrada.De Otherwise,
WARNNIG
you could lock.
The phenomenon of turbidity
The water entering the cooler circulates through
oxygen and nitrogen. When it is contacted with air,
the pressure drops rapidly and the oxygen and
nitrogen is oversaturated and generate gas bubbles.
Temporarily, water can have a cloudy appearance
due to these bubbles of oxygen. After a few seconds,
water is colorless.
and try again.
2012.3.31 9:50:26 AM