EdilKamin CORAL 1 Installation, Usage Et Maintenance page 18

Cleaning the glass (only perform when the stove is cold) Cleaning the glass (only perform when the stove is cold)
(ONLY for CORAL 1 and IVORY) (ONLY for CORAL 1 and IVORY)
- open the door outwards using the appropriate utensil (cold - open the door outwards using the appropriate utensil (cold
handle supplied 2 - Illustr. 7) to operate the pawl plate located handle supplied 2 - Illustr. 7) to operate the pawl plate located
on the side jamb of the door (rotate by 90°); on the side jamb of the door (rotate by 90°);
- close after cleaning using the pawl plate again. - close after cleaning using the pawl plate again.
fi g. 7
(ONLY for CORAL (ONLY for CORAL 2)
- Lift the door fully, turn the latch plate positioned on the - Lift the door fully, turn the latch plate positioned on the
upright at the side of the door 90° using the "cold hand" handle upright at the side of the door 90° using the "cold hand" handle
supplied, and swing open. (3 - Illustr. 8). supplied, and swing open. (3 - Illustr. 8).
- close after cleaning using the pawl plate again. - close after cleaning using the pawl plate again.
fi g. 8
(ONLY for CORAL 3) (ONLY for CORAL 3)
The door can ONLY be opened (for loading wood and cleaning The door can ONLY be opened (for loading wood and cleaning
the glass) outwards using the fi xed handle (4 - Illustr. 9). the glass) outwards using the fi xed handle (4 - Illustr. 9).
- open the door outwards using the fi xed handle located on the - open the door outwards using the fi xed handle located on the
right hand side of the stove (turn by 90°) right hand side of the stove (turn by 90°)
- use the same handle to close the door after cleaning - use the same handle to close the door after cleaning
fi g. 9
MAINTENANCE
2
3
4
Cleaning the glass pane
To clean the inside glass surface, we recommend using
GLASSKAMIN available at your retailer EDILKAMIN.
Do not clean the glass during stove operation or while hot!
NOTE: ceramic glass withstands high temperatures, but it
is fragile, so protect it from accidental blows.
Cleaning the fl ue
This must be done before periods of stove use and every
time you notice a layer of soot and tar (easily fl ammable
substances) on the inside of the duct. When deposits reach
a thickness of 5 - 6 mm, high temperatures and sparks may
set them on fi re with serious consequences for both the
fl ue and your home.
Cleaning is recommended at least once a year.
TROUBLESHOOTING
Most of the times apparent inconveniences are caused by di-
stractions or a non-workmanlike installation. However, below
is shown what to do in the most frequent cases.
1) In the event smoke escapes from the mouth of the fi re-
box, make sure that:
The installation has been carried out correctly (smoke duct,
fl ue, chimney pot). The wood is dry.
2) In case of uncontrolled combustion, make sure that:
The smoke valve is not too open The door seals are in place.
The fi rebox door is tightly closed.
3) In case the glass gets easily dirty, make sure that:
The wood is dry.
However, keep in mind that after a few hours of operation, it is
normal that a a slight layer of dust deposits on the glass.
In the event the inconvenience cannot be solved, please
contact your dealer.
IMPORTANT!!!
In the case of a fi re in the stove, in the fl ue or in the chimney,
proceed as follows:
- Use a carbon dioxide (CO
- Call the fi re brigade
DO NOT ATTEMPT TO PUT THE FIRE OUT WITH
WATER!
After the event, have the appliance checked by an authorised
Service Centre and have an authorised technician check the
fl ue.
- 18
-
) extinguisher
2