Settings; User Guide; Adjusting The Mobile Handset - Extel MOBI Guide D'installation Et D'utilisation

• Intercom panel (fig.7)
Tip: we recommend that you use protective sleeving when doing the (intercom panel and electric latch) cabling in
order to protect the cables against breakage and bad weather.
To avoid problems caused by oxidation or bad contacts, do not cut off any surplus 6 conductor cable. It is better
to roll the wires up and hide them between the pillar and the electronic control box (fig. 5).
1. Undo the crosshead screw (A) (fig.7).
2. Tip the intercom panel (B) forwards and detach it from the bottom.
3. In order to avoid water ingress from rain running down the wall, seal the back of the box with silicone (C) (fig. 5)
Warning: to avoid condensation, the seal must only cover the top half of the box (C) (fig.8).
4. Use the 3 screws (F) to fix the box (C) tight to the wall, in such a way that the hole (D) is in front of the cable
(E). 5. Feed the connection cable through.
6. Connect the 6 cables (E) (fig.6-7) to the back of the intercom panel, making sure you follow the colour coding
(fig.8). M- white / M+ grey / S- pink / S+ purple / C- black / C+ red
7. Replace the intercom panel and do up the screw (A) (fig.7)
To finish installing the outside part, insert 4 x LR 20 1.5 V alkaline batteries into the electronic control box
battery compartment by pivoting its cover, take care to observe the correct polarity (fig. 9b).
d.Connecting the automatic device and lock/latch to the electronic control box
(fig. 10)
Connect your latch and gate automation system by following the circuit diagram (fig. 10A).
e. Settings
(fig. 10a)
Adjust the intercom panel volume before closing the box (A: mic B: loudspeaker).
The volume is adjusted by pressing button A or B. Each press of the button increases the volume.
1 2 3 4 5
There are 5 volume levels from quiet to loud:
You also have the option of supplying the electronic control box with a 12/24 V or
12/24 V~ low voltage power supply (fig. 10 a). Choosing this option also makes additional features available (p7-b).
Close the battery cover and replace the top electronic control box cover using the 6 crosshead screws (H)
(fig.10b), taking care not to deform the watertight seal.

5. USER GUIDE

a. Configuring the mobile handset
• Setting the menu language
By default, the menu language is set to French.
- Press the display button on the left-hand side of the handset to enter the menu
- Select the «settings» icon , then press [OK] to confirm.
- Select «language»
- Then choose one of the 7 languages available: English, German, French, Italian, Spanish, Dutch or Portuguese.
- Press [OK] to confirm.
• Adjusting the mobile handset ringer
1. Press [Menu] and navigate to the symbol, then press [OK] to open the ringer menu.
2. The ringtone will then be detected. Use the keys to select a different melody.
3. Use the keys to adjust the ringer volume under the «Volume» function.
4. Press [OK] to confirm the changes or [Return] to exit the menu without saving the changes.
Please note: The ringer volume can be adjusted from 1 to 5 (5 = loudest setting 1 = quietest setting)
CFI EXTEL MOBI - 11/2012
GB5
http://www.bakonline.net/