Connecting A Gate Motor; Connecting An Additional Camera Or Additional Intercom Panel (Optional); Connecting An Additional Monitor (Optional); User Guide - Extel Nova Guide D'installation Et D'utilisation

c. Connecting a gate motor (fig. 6)
Connect terminals 3 and 4 directly to the back of the intercom panel. The intercom panel has a "dry" contact with
no current that should be connected to the "push button" control of your automatic opener.
Note that this function is only available when the screen is displaying the video from out-
side. A light appears as confirmation.
d. Connecting an additional camera or additional intercom panel (optional)
Wires to use: • 2 x 0.6 mm wires from 5 to 25 m • 2 x1.5 mm² wires from 5 to 100 m
1. Connect the wires according to the wiring diagram (fig.6).
2. To connect the camera, there is no need to respect the polarity.
3. To connect the additional intercom panel, there is no need to respect the polarity.
e. Connecting an additional monitor (optional)
Wires to use: Two 1.5 mm² wires
Maximum distance between the 2 monitors: 125 m
Maximum distance between the intercom panel and additional monitor: 125 m
1. Connect the wires according to the wiring diagram (fig.6).
2. To connect the monitor, there is no need to respect the polarity.
IMPORTANT: do not use a main monitor (master) as a secondary monitor (slave)

6. USER GUIDE

a. Videophone settings
(fig.2)
4 settings can be accessed from the top of the monitor:
• Melody selection (6 bell sounds available) (3).
• Light settings (4.)
• Volume settings for the melody (6).
• Volume settings for sounds coming from outside and videos (5).
b. Lens settings
(8, fig. 3)
If you notice that the camera lens is not correctly aligned when installing the monitor and the intercom panel in
their final positions, you can compensate for this misalignment using the adjustment holes located on the back of
the intercom panel. Warning, you can only compensate by a few centimetres in height.
c. General information
• To access the videophone's menus press the key.
• To confirm your choice press the key corresponding to .
• To go back to the previous menu or delete a file, press the key corresponding to .
• To navigate use the keys corresponding to and .
• The round orange led flashes at the bottom of the screen to indicate that a visitor has called and that a photo
or video was taken; you will find these recordings in the photo or video folder, depending on your configuration *.
• If no keys are pressed within 1 minute, the screen turns off completely (it will turn back on automatically during
a new call or if a key is pressed).
• If the power is cut for more than 7 hours, the dates and times must be reconfigured.
• When the SD memory is not sufficient (maximum 32 Go), the oldest photo/video is replaced by the new image.
• When the internal memory is not sufficient, the oldest photo is replaced by the new photo.
* The visitor memory function is activated originally in photo mode. To activate the video mode, insert an SD card and follow
the instructions in section 6d.
d. Using the basic functions of the videophone
• Pressing the button on the intercom panel activates a sound and the monitor turns on for about 30 seconds.
Once the visitor has been identified, press the key to begin talking.
Note: Pressing the key once is sufficient to establish communication with the intercom panel.
CFI EXTEL NOVA / NOVA WHITE / ICE - 11/2016
GB5