Festool CTM 26 E Notice D'utilisation page 21

Automatic cleaning
Activate AutoClean or set the frequency using
the rotary knob [1-8] (depending on the mobile
dust extractor variant).
Manual cleaning
Turn the switch [1-11] to the AC symbol.
Full manual cleaning
► Cover the end of the nozzle or suction hose
with your hand or CT-VS closing slide for
two seconds.
► Turn the switch [1-11] to the AC symbol.
8.3 Special features of the CTM 36 E AC-
LHS
To use the mobile dust extractor in combination
with the PLANEX:
► Use kink-resistant suction hose D 36 mm x
3.5 m-AS.
► Use a special suction sleeve for connecting
the PLANEX.
► Use closing slide CT-VS between the intake
opening [1-2] and suction hose.
► Attach the tool holder.
► Always use with a disposal bag!
8.4 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
► Use a filter or disposal bag when extracting
hazardous materials!
► Do not use the machine if the volumetric
flow monitoring function is inactive.
Observe the following when extracting dust
generated by operating electric power tools:
If the exhaust air is discharged back into the
room, the air renewal rate L within the room
must be sufficient. The volume of air dis­
charged back into the room must not exceed
50% of the fresh air volume flow (room volume
V x air renewal rate L
R
vant regional regulations.
Remember: A moist main filter clogs more
quickly when extracting dry materials. There­
fore, dry the main filter before extracting dust
or replace the damp filter with a dry one.
8.5 Extracting wet materials/liquids
Remove the filter/disposal bag.
Use a special wet filter (NF-CT).
The dust extraction stops automatically when
the maximum fill level is reached.
). Observe all the rele­
W
It must be ensured that the machine (main fil­
ter, suction hose, container, etc.) is sufficiently
dried after extracting wet materials.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and liquids
► Switch off and empty the machine immedi­
ately.
8.6 After finishing work
► Variants with AutoClean only: Clean the
main filter automatically or manually (see
section 8.2 ).
► Switch off the mobile dust extractor and
pull out the mains plug.
► Wind up the mains power cable.
► Empty the dirt trap.
► Close the extractor connector [1-2] using
the plug [1-1].
WARNING
Hazardous dust
Damage to the respiratory passage
► Before removing the mobile dust extractor
from the contaminated area, clean it and
all accessories by thoroughly vacuuming
and washing them down (interior and exte­
rior).
► Parts that cannot be thoroughly cleaned
must be sealed in an airtight plastic bag
during transportation.
► Wear a dust mask.
Only store this machine indoors.
► Place the mobile dust extractor in a dry
room inaccessible to unauthorised users.
English
21