Remove The Brushroll; Replace The Belt - Dirt Devil FD50100 Guide D'utilisation

REMOVE THE BRUSHROLL

Note: Be sure to switch off the unit, unplug & remove the clean & dirty water tanks before servicing.
1. Flip your carpet washer
on its side like this.
3. Keeping tension on
the belt, use two hands
to lift the brushroll up
and out.
For Belt Style 30 replacements, please call 1-800-321-1134 or visit our website at
www.DirtDevil.com to locate a dealer nearest you.
16
CAUTION
To reduce the risk of injury from moving parts, unplug
cleaner before servicing. Rotate brushroll manually to
make sure belt is not twisted or pinched.
2. Use a Phillips screwdriver
to remove the 3 screws
here. Now pull cover off.
4. Replace belt cover and
secure with the three
screws.

REPLACE THE BELT

1. Take off cover (Refer to
page 16). Remove and
toss the old belt out.
3. With belt in place, pull and
slide brushroll into the
nozzle, making sure that
the brushroll ends are in
the correct orientation (A).
A
Any other servicing should be done by an authorized service representative. If appliance is
not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center prior to continuing use.
2. Place the new belt on
the motorshaft, then slip
it in the area without
brushroll bristles.
4. Replace belt cover and
secure with the three
screws.
17