Unpacking; Control Panel Description Pag; Technical Data Pag; Preliminary Operations Pag - Nilfisk SR1005B Mode D'emploi Et D'entretien

UNPACKING

When the machine is delivered, carefully inspect
the shipping carton and the machine for damage. If
damage is evident, save the shipping carton so that
it can be inspected by the carrier that delivered it.
Contact the carrier immediately to file a freight
damage claim.
Please check that the following items have been
supplied with the machine (Fig. 1) :
- Plastic bag with cables for batteries and connector
for battery-charger
- Documents (Spare Parts Catalog, Manual for Use
and Maintenance, Service Manual)
- Side brush
CONTROL PANEL DESCRIPTION
1 -Emergency stop switch
2 -Drive control (paddle)
3 -Display
4 -Voltmeter/ hour meter button
5 -Brush/ fan button
6 -Center main broom lamp
7 -Light switch
8 -Starter key
9 -Left side broom lever (optional)
10 -Flap lifter pedal
11 -Speed selector switch
12 -Brake lock pedal
13 -Brake pedal
14 -Right side brush lever
15 -Dust control lever
16 -Filter shaker button
2
3
1
16
7
9
10
FIG. A
4
5
6
11
8
15
12
13
TECHNICAL DATA
TECHNICAL DATA
Voltage
Front drive motor rating
Fan-main brush motor
Side brush motor
Forward speed
Reverse speed
Max slope
Main brush
Side brush
Cleaning width with 1 side
brush
Cleaning width with 2 side
brushes
Panel paper filter (std.)
Polyester filter
Antistatic filter
Filter shaker motor
Fan speed
Vaacum in main broom
compartment
Traction/front wheel (NR.1)
Rear wheels (NR.2)
Hopper container capacity
Machine length
Machine Width
Height (from handle)
Batteries
Weight without batteries
PRELIMINARY OPERATIONS
The electric version requires two 12V batteries .
Depending on the country where it was sold, there
are three possibilities:
1 -the batteries are supplied with the machine and
they are assembled, complete with acid solution
2 -the batteries are supplied with the machine and
they are assembled, but not complete with acid
solution.
3 -the batteries are not supplied with the machine .
The battery compartment is under the seat. Lift the
seat cover and verify which one of the three
possibilities applies to the machine.
14
1. If the batteries are assembled open one of the
ventilation caps to check if it is complete with acid.
If so:
1.a Check the level of the solution in each cell and
fill up with distilled water only.
1.b Proceed with charging the batteries. (see the
"Recharging battery" section).
2
56041505(2)2001-01
VALUES
24V
400 W – 165 RPM
750 W – 3500 RPM
60 W – 70 RPM
Max 5,2 km/h ( 3.2 mil/h)
Max 2,7 km/h ( 1.7 mil/h)
16 %
Ø 265 mm x 600 mm – 635 RPM
Ø 420 mm – 70 RPM
820 mm ( 32 in)
1000 mm (40 in)
2
2,5m (0.19 sq ft.)–from5 to 8µm
2
2,5m (0.19 sq ft.)–5 µm
2
2,5m (0.19 sq ft.)–1 µm
24 V- 30W
3500 RPM
5-22 mm/H O (0.2-0.9 in/ H
2
Ø 200 mm (7.8 in)
Ø 200 mm ( 7.8 in)
53 l ( 14 gal)
1296 mm (51 in)
754 mm (30 in)
1165 mm (46 in)
2 x 12V 130Ah@20
134 kg (296 lb)
O)
2