After Use; Safety Check - Williams Dieseljet 445 Manuel D'utilisation

Masquer les pouces Voir aussi pour Dieseljet 445:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Fire Extinguisher
Inspect system pressure regularly; refer to the extinguisher label for Pressure/Temperature
Table. In some conditions the extinguisher may require resetting; this is done by pressing
the extinguisher reset button found on the extinguisher display unit, refer to Boat System
Arrangement for its location.

Safety Check!

ALWAYS attach yourself to the safety lanyard when engine is running. Before
WARNING.
setting off as a precautionary measure always test lanyard for its functionality by pulling
away from its seating – engine should always stop.
NEVER operate the boat when bathers are using the boarding ladder, risk of
WARNING.
serious injury exists from reverse deflector.
NEVER investigate engine bay with engine running or ignition on.
WARNING.
Starting Your Dieseljet
NEVER run engine if ambient temperature is excessively high or below -16°C (-5°F).
NEVER attempt to switch off engine using battery isolator.
Ensure boat is in a depth of at least 0.95m/3ft of water before attempting to start
engine.
Ensure all passengers are correctly seated.
1 Turn on battery isolator.
2 Secure any loose ropes that could get sucked into jet unit.
3 Ensure shift lever is in neutral position.
4
Connect safety lanyard to switch.
Personal injury may result if not attached.
WARNING.
5 Test safety lanyard for correct functionality (see Safety Check! above).
Warning Lamps/Alarms
Risk of engine damage. In the event that a warning lamp or buzzer activates
CAUTION.
during use, STOP engine immediately, investigate cause and refer to engine manual.
Contact your authorized Williams Dealer.
14
www.williamsjettenders.com

After Use

To prolong life it is very important to wash entire boat with fresh water after use and
prior to storage, especially the jet pump area. Failure to carry out fresh water washing
will significantly reduce the life of underwater components. Check anodes routinely.
Flush engine (refer to Flushing Procedure)
Wash jet pump
Check bilge of boat and dry any residual water
Rinse footwells and upholstery with fresh water
Isolate battery
3
3
1
1
2
1 Pump anodes 2 Hull anode
3 Reverse bucket anodes
1
www.williamsjettenders.com
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dieseljet 505Dieseljet 565Dieseljet 625

Table des Matières