Power Supply Installation; Lock Release Installation - golmar Rock Serie Manuel D'installation

POWER SUPPLY INSTALLATION

I
nstalling the FA-PLUS/C Rev.938072 power supply.
3,5 x 45
DIN-7971
The power supply can be installed on a DIN 46277
guide simply pressing it. To disassemble the power
supply from the DIN guide, use a flat screwdriver
to lever the flange as shown on the picture.
The power supply uses 6 units over DIN guide.
Replace the protection cover once the input terminals have been wired.

LOCK RELEASE INSTALLATION

L
ock release installation.
If the lock release will be installed in a metal door, use a
Ø3,5mm. drill and tap the hole.
In case of wood door, use a Ø3mm. drill.
IMPORTANT: The Kit allows the activation of an alternating current lock release already
connected to the installation, as long as its consumption does not exceed
600mA. We recommend using the 'Golmar' 12Vac lock release (cod.
20600140, not included in the kit).
Install the power supply in a dry and protected place.
3,5 x 45
It's recommended to protect the power supply by
DIN-7971
using a thermo-magnetic circuit breaker.
To install the power supply directly on the wall, drill two
holes of Ø6mm. and insert the wallplugs. Fix the
transformer with the specified screws.
DIN 46277
3,5 x 25
DIN-7972
M 4 x 8
DIN-963
47