Driving And Cutting - BEAL NPBR065/61 Notice D'emploi

gb
4.4

DRIVING AND CUTTING

MOVING
CAUTION Be very careful when rever-
sing. Never change direction of move-
ment without first stopping the machine.
1) Start the engine (see paragraph 4.3).
2) Sit in the driver's seat.
3) Move the speed change lever as required
(fig.39 part 3).
4) Increase the number of engine revs (if too
low).
5) Release the parking brake by pressing the bra-
ke/clutch pedal (fig.38 part 1)
6) Slowly release the brake/clutch pedal to start
forward movement of the machine.
6) Use the fastest gear "4" only for moving from
one place to another and with the blade disen-
gaged.
CAUTION This machine is not homo-
logated for travelling on public roads.
It must only be used in private areas,
closed to traffic.
STOP
1) Press the brake/clutch pedal to stop the ma-
chine.
GRASS CUTTING
Before starting reverse travel "R", lift and
disengage the blade.
CAUTION The reverse gear cannot be
engaged with the cutting blade engaged.
The engine would switch off immediately.
1) Start the engine (see paragraph 4.3).
2) Sit in the driver's seat.
3) Place the throttle control level to the maximum
position .
4) Select the speed change lever on one of the
first 3 gears (fig.39 part 3).
5) Operate the cutting blade by lifting the
engaging lever (fig.39 part 2).
6) Lower the blade deck to the required height
(fig.39 part 1)
7) Release the parking brake (fig.38 part 1)
8) Slowly release the brake/clutch pedal.
42
INSTRUCTION MANUAL
EMPTYING THE GRASS BAG
If the cut grass remains on the ground, this means
the grass bag is full:
1) Move to the cut grass emptying and storage
area.
2) Stop the machine and operate the parking bra-
ke.
3) Cutting blade disengaged.
4) Remove the bag overturning lever as shown in
fig.44-45.
5) Overturn to empty the contents (see fig.46).
6) Lower the bag so it completely adheres to the
rear cover; if it does not, the safety switch will pre-
vent blade engagement.
CLEANING THE GRASS UNLOADING PIPE
Grass could block the pipe due to:
- bag full
- speed too high
- grass too high
Proceed as follows:
1) Operate the parking brake.
2) Disengage blade rotation.
3) Lift the blade deck as far as it will go.
4) Switch off the engine and remove the key.
5) Release the bag.
7) Remove the accumulated grass from the rear
part of the pipe.
CUTTING SUGGESTIONS
CAUTION The machine is not suitable for hea-
vy-duty work and for mowing large quantities
of grass.
# When adjusting the cutting height and machine
speed, be careful not to overstress the machine.
# For problem-free use, the cutting height and the
movement speed must be adapted to the height of
the grass to be cut.
CAUTION Pedal release must always be
gradual to prevent sudden engagement
of the drive causing the vehicle to jump
forward, with loss of control by the driver,
especially on slopes.
CAUTION This operation must always be
performed with the engine switched off
and the ignition key removed.