Product Description And Specifications; Intended Use; Product Features - Bosch GTS 18V-216 Professional Notice Originale

Symbols and their meaning
and raising (work position) the saw
blade.
Right-hand side:
Indicates the position of the locking lever
for securing the saw blade and setting
the bevel angle (saw blade can be swiv-
elled).
The CE mark provides confirmation from
the manufacturer that the power tool
complies with the applicable EU Direct-
ives.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.

Intended use

The power tool is a stationary machine for cutting in a
straight line with and against the grain in hardwood, soft-
wood, chipboard and fibreboard. Mitre angles of –30° to
+30° as well as bevel angles of 0° to 45° are possible.
It is also possible to saw aluminium profiles and plastic using
the appropriate saw blades.

Product Features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Scale for spacing between saw blade and parallel
guide
(2) Angle guide
(3) Protective cover
(4) Riving knife
(5) Parallel guide
(6) Saw table expansion
(7) Angle guide storage compartment
(8) Mounting holes
(9) Ring spanner (23 mm; 13 mm)
(10) Hex key (5 mm)
(11) Bracket for storing the protective cover
(12) Push stick
(13) Clamping handle for saw table expansion
(14) Hand wheel
(15) Crank for raising and lowering the saw blade
(16) On/off switch
a)
(17) Battery
Bosch Power Tools
(18) Stop for 45° bevel angle
(19) Scale for bevel angles
(20) Locking lever for setting the bevel angle
(21) Angle indicator (vertical)
(22) Stop for 0° bevel angle
(23) Saw table
(24) Adjusting screw for adjusting the clamping force of
the parallel guide
(25) Table insert
(26) Saw blade
(27) Guide groove for parallel guide
a)
(28) Battery release button
(29) Carrying handle
(30) Guide groove for angle guide
(31) Dust extraction adapter
(32) V guide groove on the saw table for the parallel
guide
(33) Base grid
(34) Locking screw for base grid
(35) Clamping lever/clamp markings
(36) Clamping lever for riving knife
(37) Positioning pins for riving knife
(38) Table insert locking screw
(39) Clamping lever for protective cover
(40) Guide pin for protective cover
(41) Clamping handle for parallel guide
(42) V guide for parallel guide
(43) Additional parallel guide
(44) "Additional parallel guide" fastening set
(45) Guide rail for angle guide
(46) Lower saw blade cover
(47) Tab for lower saw blade cover
(48) Gripping hole for lifting the table insert
(49) Clamping nut
(50) Spindle locking lever
(51) Clamping flange
(52) Mounting flange
(53) Tool spindle
(54) Locking knob for all mitre angles
(55) Angle indicator on the angle guide
(56) Scale display
(57) Saw table spacing indicator
(58) Cross-head screw for setting the 0° stop
(59) Screw for bevel angle indicator
(60) Cross-head screw for setting the 45° stop
(61) Hex socket screws (5 mm) on the front for adjusting
the parallelism of the saw blade
English | 35
1 609 92A 6SY | (01.09.2021)