Product Description And Specifications; Product Features; Technical Data - Bosch GTA 60 W Professional Notice Originale

Safety Instructions for Saw Stands
Disconnect the plug from the power source and/or re-
u
move the battery from the power tool before making
any adjustments to the power tool or changing ac-
cessories. Accidents can occur when power tools are
started unintentionally.
Assemble the saw stand properly before mounting the
u
power tool. Correct assembly is important to prevent the
risk of collapsing.
Firmly secure the power tool to the saw stand before
u
using it. You may lose control of the power tool if it slips
on the saw stand.
Place the saw stand on a firm, flat, horizontal surface.
u
If there is a chance that the saw stand will slip or wobble,
the safe and steady machining of the workpiece cannot
be guaranteed.
Do not overload the saw stand or climb or stand on it.
u
Overloading or standing on the saw stand can raise its
centre of gravity, causing it to tip over.
Ensure that all screws and connecting pieces are
u
tightly fastened during transport and when carrying
out work. Loose connections can cause instability and in-
accurate sawing.
Only install and remove the power tool when it is in
u
the transport position (for information on the trans-
port position, also refer to the operating instructions
for the relevant power tool). Otherwise the power tool
may have an such unfavourable centre of gravity that you
will not be able to hold onto it securely.
Operate the power tool secured to the mounting plate
u
on the saw stand only. Without the saw stand, the
mounting plate with the power tool will not be stable and
can tip over.
Ensure that long and heavy workpieces do not unbal-
u
ance the saw stand. The free end of long and heavy
workpieces must have something placed underneath it or
be supported.
When folding or unfolding the saw stand, keep your
u
fingers away from hinge areas. There is a risk of fingers
being crushed.
Symbols
The following symbols may provide you with important in-
formation about the use of your saw stand. Please take note
of these symbols and their meaning. Knowing what these
symbols mean will help you to use your saw stand more ef-
fectively and more safely.
Symbols and their meaning
The maximum load bearing capacity
(power tool + workpiece) of the saw
180
stand is 180 kg.
kg
Bosch Power Tools
Product description and
specifications
Intended Use
The saw stand is intended for holding the following Bosch
benchtop saws (stand 2020.10):
– GTS 10 (3 601 L30 2..)
– GTS 10 J (3 601 M30 5..)
– GTS 10 XC (3 601 L30 4..)
– GTS 635-216 (3 601 M42 0..)
– GTS 18V-216 (3 601 M44 0..)
The saw stand and power tool are intended for cutting
boards and profiles.
The saw stand is also suitable for various competitor
products (see "Securing the Power Tool to the Mounting
Plate (see figure G)", page 12).

Product Features

The numbering of the components shown refers to the illus-
trations on the graphics pages at the beginning of the
manual.
(1) Mounting plate
(2) Locking mechanism
(3) Handle
(4) Lock bolt
(5) Height-adjustable foot
(6) Upper frame with locking mechanism
(7) Lower frame
(8) Wheel
(9) Linkage bar
(10) Foot support
(11) Fastening set
(12) Wing nut

Technical Data

Saw stand
Article number
Saw stand height
Max. load bearing capacity
(power tool + workpiece)
Weight according to EPTA-Pro-
cedure 01:2014
English | 11
GTA 60 W
0 601 B12 0..
mm 622
kg 180
kg 24
1 609 92A 5YD | (10.11.2020)