Environmental Protection - Worx WG259E Traduction Des Instructions Initiales

OPERATION
Starting and stopping
Top cutting
WARNING: If any parts
are missing, damaged
or broken, do not operate your
hedge trimmer until all damaged
parts have been replaced or
repaired. Failure to do so could
result in serious personal injury.
DO NOT USE WITHOUT FRONT
HANDLE AND SAFETY GUARD.
Side cutting
Lubricating the Cutting Blade
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be
12
activated on three sides, giving you many
choices for a comfortable grip. Before cutting
an area, inspect it first and remove any
foreign objects that could become thrown
or entangled in the blades. Always hold the
trimmer with both hands and with the blade
away from you before turning it on.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade. (See Fig. E1& E2)
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
cutting blades away from people and objects
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levels (5 &
6) before attempting to clear jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. E1). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
Cordless Hedge Trimmer
results.
SIDE CUTTING
See Fig.
When trimming the sides of the hedge, begin
D1, D2 at the bottom and cut upwards (See Fig.
E2), tapering the hedge inward at the top.
This shape will expose more of the hedge,
resulting in a more uniformed growth.
See Fig. MAINTENANCE
E1
Remove battery before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
See Fig.
with a dry cloth. Always store your power tool
E2
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
See Fig.
F
ENVIRONMENTAL
PROTECTION
Waste electrical products must not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer
for recycling advice.
EN