Removing The Lid Lock - Whirlpool Maytag MVW6200KW Manuel Technique

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug washer or disconnect power.
2. Turn off water supply to washer.
3. Disconnect hot and cold inlet water hoses.
4. Complete the steps 1-8 from section Removing the Console.
5. Disconnect the Lid Lock connector from the Main Control.(Connector
number varies depending on model features).
6. Feed the Lid Lock harness through the opening in the washer Top Panel.
38
FOR SERVICE TECHNICIAN'S USE ONLY

Removing the Lid Lock

7. Disconnect push-mount clip from Top Panel.
8. Complete the steps 1-8 from section Lifting the Top Panel.
9. Remove the Lid Lock harness from the clips on right side of Top Panel
as shown in below figure.
10. Remove the lid lock bezel by pressing the retaining tabs away from the
lock.
11. Remove the Lid Lock from the Top Panel by pressing down on the tab
as shown in below figure.
DO NOT REMOVE OR DESTROY