Button Activation & Encoder Test; Service Test Mode - Whirlpool Maytag MVW6200KW Manuel Technique

BUTTON ACTIVATION & ENCODER TEST
NOTE: The Service Diagnostic mode must be activated before entering the
Button Activation & Encoder Test; see procedure on
Entry Procedure
Press and release Key 1 used to activate Service Diagnostic mode.
The following test will be available:
DIAGNOSTIC: Button Activation & Encoder Test
The Encoder Test will be active immediately after successfully entering into the
Button Activation & Encoder Test:
➢ When the Encoder Test starts, one of the LED from status indicator group
will be turned ON.
➢ Rotate the knob CW/CCW from the current position until a full knob
rotation is completed. Notice that the LEDs from Status indicator group
will turn ON/OFF while the knob is rotated. After the Encoder Test is
completed, all the LEDs will be turned ON and the Button Activation test
will be active.
Button Activation Test
Pressing each button will toggle ON/OFF its corresponding LEDs:
➢ LED group 1 will toggle ON/OFF with Key 1.
➢ LED group 2 will toggle ON/OFF with Key 2.
➢ LED group 3 will toggle ON/OFF with Key 3.
➢ LED group 4 will toggle ON/OFF with Key 4.
➢ LED group 5 will toggle ON/OFF with Key 5/START.
➢ LED group 6 will toggle ON/OFF with Key 6/POWER.
➢ If LEDs do not toggle ON/OFF after pressing buttons and rotating the
cycle selector knob go to TEST: #4 HMI.
Exit Procedure
To exit Button Activation & Encoder test, press and hold Key 1 used to activate
Service Diagnostic mode.
DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN'S USE ONLY
page 11.

SERVICE TEST MODE

NOTE: The Service Diagnostic mode must be activated before entering Service
test mode; see procedure on page
NOTE: If, at any point, the user presses the POWER button or opens the door
when not requested by the test sequence during Service test mode, the washer
exits to standby mode.
NOTE: Door must be closed to perform test.
Active Fault Code Display in Service Test Mode
If the display begins flashing while in Service test mode, it is displaying an active
fault code. Active fault codes are codes that are currently detected. Only one
active fault code can be displayed at a time.
Entry Procedure
To enter Service test mode, press and release Key 2 used to activate the
Service Diagnostic mode then press and release the START button. All LEDs
will turn ON indicating that the Service test mode entry was successful.
Perform All Tests: After pressing the START button, the test sequence from
page 14 will start.
Exit Procedure
When the test is complete, press the POWER button to exit Service test mode
and return to standby mode.
11.
13