Component Locations - Whirlpool Maytag MVW6200KW Manuel Technique

6. If the preceding steps did not correct the lock problem, replace the main control.
a. Unplug washer or disconnect power.
b. Replace the main control.
c. Reassemble all parts and panels.
d. Plug in washer or reconnect power. Perform Service Diagnostics to verify repair.

COMPONENT LOCATIONS

Cold water Valve
Hot water Valve
Run Capacitor
DO NOT REMOVE OR DESTROY
FOR SERVICE TECHNICIAN'S USE ONLY
Figure 7 - Main Control (ACU)
PSC Motor Connector
Shifter Assembly Connector
Figure 8 - Bottom View - PSC
J5
J1 J8 J4
J6
Drain Pump
J2
PSC Motor Connector
Drive Belt
Shaft Pulley
Shifter Assembly
29