Checklist - HOESCH NEVADA Instructions De Montage Et D'utilisation

3. Lift up the catch (3) and remove the safety ring (4,
turn).
4. Pull off the cap (5).
5. Remove the fi lter (6).
6. Insert a new fi lter.
7. Replace the cap on the fi lter unit.
8. Place the safety ring on the unit and turn it until the
catch locks into place. Lift up the catch and continue
to turn the safety ring until the catch locks into place a
second time. You will still be able to move the safety
ring slightly.
9. Close the deaeration screw.
10. Place the cover back on the unit.
1
2
5
Cleaning the filter system (Nevada)
Before replacing / cleaning the fi lter cartridge, be sure to
unplug the power cord. The fi lter can be removed from the
skimmer without draining the pool, but keep in mind that this
may cause leakage of water contained inside the skimmer.
For this you should close the safety valves located at the
skimmer (A) and the circulation pump (B).
A B
The fi lter insert is located inside the skimmer. In order to
remove the fi lter insert, the seal lock has to be pulled up 1.)
so that it can be used to release the seal, 2.) take off the
cover 3.) and remove the fi lter insert.
Sediment and debris from the fi lter should be removed by
running water under the tap or using water from a garden
hose at low pressure.
3
4
21

Checklist

On the basis of this checklist you can quickly and
effortlessly deal with defects occurring in your whirlpool.
Work connected with the electrical installation can only
be performed by authorized experts in this fi eld. Before
commencing electric works you should switch off the
6
whirlpool from the power supply!
Defects Reason
The pump Lack of the power
is not voltage
working 230 V, 50 Hz
Burnt fuse
Released motor
protection against
overheating
Control unit electronics Turn the jet nozzle as far to the
The massa- Massage jets
ge stream
is getting
weaker
What you should do when ...
during whirl bathing foam appears?
■ Immediately switch the Whirl system and Air-Injection
off! Drain and rinse the bathtub thoroughly. Remember
to use only appropriate additives for bathing (the ones
that do not foam and do not contain oils)!
1
3
Remedy
Switch on the initial protection
and/or the current trip device
(FI)
Exchange of fuse by an expert
Let the motor cool down
left as possible.
Turn the jet nozzle as far to the
left as possible until you feel
no further resistance. Then
remove the jet nozzle, clean it
and push it back in.
2
4
GB
33