Possible Malfunctions - Bartscher 200240 Mode D'emploi

Storing the device
o If the device is not used for a long time, clean it according to the above description
and store in a dry, clean place, protected against cold, sun and, children.
Do not place any heavy objects on the device.

7. Possible Malfunctions

In case of malfunction, disconnect the device from its power source. Before contacting
the service or sales agent, verify - based on the table below - whether it is possible to
eliminate disruption in operation.
Problem
The device does not
work. Neither the red
power diode in the mains
switch nor the green
operation diode light up.
The device is switched
on, the temperature is
set, but the requested
teperature is not attained.
The device is switched on,
the temperature is set,
but the green operation
diode does not light up
and the device does not
heat up.
If you cannot remove the malfunctions:
do not open the body,
-
notify the customer service point or contact the sales
-
agent, while providing the following information:

type of malfunction;

article and serial number (rating plate at the
rear of the device).
Cause
 Plug placed wrong in
socket.
 Electric power supply
fuse actuated.
 Thermostat damaged.
 Overheat protection
actuated
Solution
 Connect plug to socket
correctly.
 Check fuse, check device
after connecting it to a
different socket.
 Contact sales
representative
 Wait until device cools
down and press RESET
button in the device
bottom plate.
- 35 -