Electrical Connection - ITV IQ400TRIE Mode D'emploi

2.3 CONNECTION TO DRAINAGE
Drainage should be located lower to the machine level, at 150 mm (5.91 inches) minimum.
It is convenient that the drainage pipe is of 30 mm (1.18 in) of interior diameter and with a minimum
gradient of 3 cm (1.18 in) per meter (see figure).
CORRECT INCORRECT
INCORRECT
ASCENDING ASCENDING
AFVOERlLIJN
DESCENDING

2.4 ELECTRICAL CONNECTION

IT IS MANDATORY TO GROUND THE EQUIPMENT.
To avoid possible discharges on individuals or damages to the equipment, the machine
should be grounded pursuant local and/or national regulations as the case may be.
THE MANUFACTURER SHALL BE HELD HARMLESS IN CASE OF DAMAGES ARISING DUE
TO THE LACK OF THE GROUND INSTALLATION.
The machine is supplied with a 1.5 m (4.92 feet) cable of length. In case the supply cable is
damaged, it should be replaced by a cable of special assembly to be furnished by the manufacturer
or post-sale service. Such replacement should be performed by qualified technical service only.
The machine should be places in such a way as to allow a minimum space between the back and
the wall to allow an easy access and without risks to the cable jack.
Safeguard the base of the jack.
It is convenient to install adequate switches and fuses.
The line up to the jack should have a minimum section of 2.5 mm2 (0.0038 in2)
Voltage and tension are indicated in the nameplate and on the technical specifications of
this manual. Variation on voltage above the 10% stated on the nameplate could result on
damages or prevent the machine start-up.
2.5 INSTALLATION OF MODULAR EQUIPMENTS OVER DEPOSITS OR SILOS
Modular makers should be installed over deposits or silos, following
the instructions contained in this manual.
The resistance and stability of the container-machine/s assembly
should be verified, as well as the fastening elements.
English_IQ_6