ITV IQ400TRIE Mode D'emploi page 5

In case the front louver is not enough, the exit is either total or partially obstructed or due to its
placement it will receive hot air from another device, we recommend, in case it is not possible to
change the location of the machine, TO INSTALL A WATER CONDENSER.
IT IS IMPORTANT THAT THE WATER PIPING DO NOT PASS BY OR NEAR SOURCES OF
HEAT SO AS NOT TO LOSE ICE PRODUCTION.
THREAD THE SUPPORT LEGS TO THE BASE OF THE MACHINE ON THE HOUSING SET TO
SUCH END AND REGULATE THE HEIGHT AS TO HAVE THE EQUIPMENT PERFECTLY
LEVELED.
IN MODULAR MACHINES
2.1 WATER AND DRAINAGE
Water quality has a remarkable influence on the appearance, hardness
and flavour of the ice as well as, on the machines condensate by water,
on the life of the condenser.
2.2 CONNECTIONS TO THE WATER NETWORK
Use a flexible pipe (1.3 m – 4.27 feet length) with the two filter joints
supplied with the machine. We strongly discourage the use of two-exit
bibs and two switches as, due to an error could close that back one,
leaving the machine without water supply.
damage call without actually existing one.
Pressure should be established between 0.7 and 6 Bar (10 / 85 psi.)
If pressures overpass such values, install the necessary corrective
devices.
>10 cm
Jack
Ventilation louver
Jack
This could result on a
>4"
Base jack
Bib
Water connection hose
Discharge hose
>4"
>10 cm
Base jack
Bib
Water connection hose
Condenser discharge outlet
Silo drainage
English_IQ_5