Dismounting - Binzel Abicor iROB Pulse 400 Mode D'emploi

11 Dismounting

11 Dismounting
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Dismounting may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Please observe the operating instructions of the welding components, coolant recirculator iROB Cool
• Observe the information given in the following chapter:
1 Disconnect the intermediate cable assembly and the connections to connected parts.
Risk of injury
Limbs can be crushed and cut.
• Use an appropriate lifting tool with load securing devices for transport and installation.
NOTICE
• Use an appropriate crane with suitable load securing devices for transport and installation of the
• Observe the safety instructions of the crane manufacturer.
2 Option: Cooling unit
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
• Observe the information given in:
3 Remove parts to be disconnected.
EN - 22
DANGER
(option), wire feeder iROB Feed (option), remote control iROB Control (option) and welding torch.
 8 Putting out of operation on page EN-19.
WARNING
iROB Pulse robot welding power source.
DANGER
 BAL.0332.0 Coolant recirculator iROB Cool
iROB Pulse
BAL.0323.0 • 2017-08-31