Product Description; The Irob System En; Nameplate - Binzel Abicor iROB Pulse 400 Mode D'emploi

3 Product description

3.3 The iROB system
Equipment and accessories of the iROB system are shown in the following table.
iROB Pulse
iROB Feed 22
iROB Feed MP (MasterPull)
iROB Cool
iROB Control
iROB Bracket
iROB Clamp
iROB Spool
iROB RI 1000/2000/3000
MF1
MP
WHPPI
Tab. 6

3.4 Nameplate

The robot welding power source is labeled with a nameplate on the housing as follows:
Fig. 2
EN - 8
Robot welding power source
Wire feeder
Connection box for MF1 MasterPull
Coolant recirculator for the robot welding power source
Remote control for the setup of the robot welding power source
Mounting platform for the wire feeder
Fastener for intermediate cable assembly on the robot
Fastening and support for K300 wire spools on the robot
Robot interface
Master feeder size 1 = roll ø 20 mm (drive unit)
Master feeder size 1 MasterPull
Designates the changeable body in the push-pull design
The iROB system
Nameplate iROB Pulse 400
iROB Pulse
BAL.0323.0 • 2017-08-31