Yamaha WR250F Manuel D'atelier Du Proprietaire page 37

Masquer les pouces Voir aussi pour WR250F:

Tool name/How to use

This tool is used for when loosening or tightening the

flywheel magneto securing nut.

Use this tool to inspect the coil resistance, output

voltage and amperage.

This tool is necessary for checking ignition timing.

This tool is needed to remove and install the valve

This tool is used to hold the clutch when removing or

installing the clutch boss securing nut.

Intake 4.0 mm (0.16 in)

Exhaust 4.5 mm (0.18 in)

This tool is needed to remove and install the valve

Intake 4.0 mm (0.16 in)

Exhaust 4.5 mm (0.18 in)

This tool is needed to install the valve guide.

Intake 4.0 mm (0.16 in)

Exhaust 4.5 mm (0.18 in)

This tool is needed to rebore the new valve guide.

This tool is used to remove the flywheel magneto.

SPECIAL TOOLS

Illustration

Chapitres