Yamaha WR250F Manuel D'atelier Du Proprietaire page 198

Ð Pass the clutch cable through the cable guide.
Ñ Fasten the starter motor lead, AC magneto lead and neutral
switch lead onto the frame. Locate the clamp end facing
toward the rear of the frame and cut off the tie end.
Ò Fasten the clutch cable, starter motor lead, negative battery
lead, AC magneto lead and neutral switch lead onto the frame.
Locate the clamp end facing toward the rear of the frame and
cut off the tie end.
Ó Pass the neutral switch lead and AC magneto lead on the
inside of the wire harness.
Ô Fasten the clutch cable, AC magneto lead and neutral switch
lead onto the frame. Locate the clamp end near the clutch
cable and cut off the tie end.
CABLE ROUTING DIAGRAM
Õ Pass the clutch cable and wire harness through the cable
guide.
Ö Locate the couplers in the frame recess.
× Pass the carburetor breather hoses, carburetor overflow hose
and catch tank breather hose so that the hoses do not contact
the rear shock absorber.
Ø Secure the coupler by pushing it into the hole in the headlight
unit.
2 - 105
SPEC