Setup; Setup Location Requirements; Electrical Connection; Complete Overview - CASO DESIGN SousVide Garer SV300 Mode D'emploi

16 Setup

16.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfill the following prerequisites:
 Attach the device only in the provided bracket at a heat restistant cooking vessel.
 The heat-resistant cooking vessel must be set up on a firm, flat, level and heat-resistant
surface. The carrying capacity of the support must be appropriate to withstand the
weight of the cooking vessel, including device, water filling and the heaviest expected
food loading.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the unit in a hot or damp environment or near flammable material.
 Do not move the cooking vessel with device when it is in operation.
 The device should not touch hot surfaces.
 The electrical outlet must be easily accessible so that the plug can be quickly
disconnected in the case of an emergency.
 The setup of this unit in non-stationary locations (e.g., boats, airplanes, motor homes)
must be carried out by a qualified electrician, provided they guarantee the prerequisites
for the safe use of the unit.

16.2 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before plugging in the unit, compare the voltage and frequency data on the vacuum
sealer's rating plate (found on the bottom of the unit) with that of your electrical
network. This data must be compatible. If in doubt consult a qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The use of a multi-plug outlet adapter is not recommended due to fire danger.
 Inspect the power cord for damage and ensure it doesn't run under the unit or over hot
or sharp surfaces.
 The electrical safety of the unit is only guaranteed if it is connected to a properly
installed protective conductor system. Use of the unit without a protective conductor is
prohibited. If in doubt, consult a qualified electrician. The manufacturer cannot be made
responsible for damages due to a missing or damaged protective conductor.

17 Complete Overview

This chapter provides you with an overview of your device and explains some of its key
features.
34