Gracenote Cd Information; Gracenote Music Recognition Database; To Update Gracenote Music; Recognition Database - Philips WACS7000 Manuel D'utilisation

The Gracenote music recognition service enables
the set to look up CD track information
(including album, artist, genre, track information)
from its built-in database. It allows the recorded
CD tracks to be properly categorized (for
example, under Artists, Albums, Genres or All
tracks) and also be merged with the existing
tracks in the hard disk.
12.1 Gracenote music

recognition database

A 800 MB CD database (contains 800,000 most
popular CDs) is embedded in every WACS7000
Center for quick look-up on track information.
An update file that contains newly released CDs
is available quarterly on www.club.philips.com for
download.

12.1.1 To update Gracenote music

recognition database
1
Use your PC to register your product on
www.club.philips.com and go to "Show Upgrades
& Support" page to download Gracenote Music
recognition database update. Note that the
updates are posted quarterly and each update is
independent of each other, i.e. a later update
could be installed without an earlier update.
2
After storing the file on your PC, you can either
burn a CD with the update file using your
favorite CD burning software and drop the CD
into the WACS7000 Center for automatic
update, or you can use WADM's Gracenote
update option if you have connected your PC to
WACS7000 Center.
12.2 Gracenote Internet Query
If the CD track information of your new CD disc
cannot be displayed on the WACS7000, the
quickest and surest solution is to look it up from
the internet by following steps below.
12.2.1 Connecting to the
Internet
1
Check that you have connected the Center to an
Access Point or Router with Internet access or
connect the Center to an ADSL modem with
internet access directly

12. Gracenote CD Information

Connect to Internet for Gracenote
Internet services
Helpful hint:
– Make sure that no dial-up, user name or
2
Set DNS and Gateway
●
If you are using a DHCP* enabled Access
Point, Router or ADSL modem, the DNS and
Gateway can be got automatically, so you need
only to set the Center to Automatic (DHCP)
mode by following steps below:
*DHCP stands for Dynamic Host Configuration Protocol. It is a
protocol for assigning dynamic IP addresses to devices on a network.
a. Press MENU
b. Press 3 or 4 and 2 to select Settings
c. Press 2 to continue
d. Press 3 or 4 and 2 to select Automatic
●
If there is no DHCP, set the DNS and Gateway
manually by following steps below:
On your PC, carry out the following steps:
a. Click Start > Run
b. Type cmd and click OK
c. Type ipconfig/all
d. Write down the DNS and Gateway of the
Internet
Router/Hub/Switch
Wireless Base Station 11g True T Wireless Base Station 11g T rue Turbo urbo
Wireless Modem PC Wireless Modem PC Power Power
DSL modem
password is required for the Internet access.
➞ Network ➞ Wired
(DHCP).
ETHERNET
for illustration only
57