Function Buttons - Klein Tools ET110 Mode D'emploi

ENGLISH
Warning
Wear approved
eye protection
TWA: Time-Weighted Average
POWER 3
A long press of the Power Button will power on and off the meter.
During the setup process, a short press will exit the current screen.
Meter will automatically power-off after 20 minutes of non-activity.
TEMP / ^
5
Press the TEMP Button to enter temperature measurement mode.
Readings wil be in Celsius
to switch to Farenheit
to increase parameter values.
BACKLIGHT /
When powered on, the backlight is off by default. Press the Backlight
Button to turn the backlight on or off. Backlight will remain on until it
or the meter itself is turned off. In Set-Up mode, the Backlight Button
is used to decrease parameter values.
MAX/AVG
7
Pressing the MAX/AVG Button will display the maximum
concentration value measures since powering-on, pressing again will
display the average (AVG) value. A long press will clear all data.
MUTE 8
A short press of the Mute Button will stop the active alarm for 3
minutes. A long press will reset the alarm.
HOLD 9
Press the HOLD Button to hold the current measurement on the
display. Press again to return to live measurement mode.
SET 10
Press the SET Button to enter Sensor Self-Test mode. For calibration,
short-press to choose parameters and long-press to save current
parameter values.
WARNING INDICATOR LIGHT
The
Warning Indicator Light is NOT a button. It flashes green when
conditions are safe, and flashes red with an accompanying audible alarm
when the alarm level is reached.
4
SYMBOLS ON METER
DEFINITIONS

FUNCTION BUTTONS

(°C )
. In Set-Up mode, the TEMP Button is used
(°F )
6
Read instructions
Not intended for use as Personal
Protective Equipment (PPE)
STEL: Short-Term Exposure Limit
by default. Press TEMP Button again
4