Step 4. Installing The Conduit - Samsung NE58F9500SS Manuel D'utilisation

STEP 4. INSTALLING THE CONDUIT

Remove the conduit connection plate and rotate it as shown below.
The conduit hole (1
1. Prepare the conduit cord as shown in Figure 1.
2. Install the conduit cord as shown in Figure 2.
For conduit installations, insert the strain relief (not included) into the conduit hole (1
the conduit cord through the body of the strain relief and fasten the ring. Reinstall the bracket.
Installing a 3-wire conduit
• Aluminum building wire may be used but it must be rated for the correct amperage and voltage.
Connect the wires as described below.
• The wire you use, the location and enclosure of splices, etc., must conform to good wiring
practices and local codes.
1. Loosen the 3 lower terminal screws from the
terminal block.
2. Insert the center bare wire (white/neutral) tip
through the bottom center terminal block opening.
On certain models, the wire will need to be
inserted through the ground strap opening and
then into the bottom center block opening.
3. Insert the two side bare wire tips into the lower left
and the lower right terminal block openings.
4. Tighten the screws until the wire is firmly secured
(35 to 50 inch-lbs.). Do not over-tighten the
screws since it could damage the wires.
5. Go to step 5 on page 26 to continue with the
installation.
NE58F9500SS_AA_AC_DG68-00499A-09_EN.indd 25
/ ") must be used.
1
8
Figure 1
1" / " 1"
3
8
3 / "
1
2
3 wire 4 wire
Knockout surface
Conduit connection plate
1 / "
1
8
1 / " 1
3
8
/ "
3
8
3 / "
1
2
terminal
English - 25
1 / "
3
8
/ "
1
8
Figure 2
Ring
Body
Strain relief
/ "). Then thread
1
8
Ground
Neutral
strap
White
Black Red
White
Black
Red
Wire tips
2/2/2016 5:40:24 PM