Control System Usage Instructions - Balboa 908 M3301 Mode D'emploi

Ⅱ、Control system usage instructions
(Ⅱ-1)、USA BALBOA control system :model GS523 or GS510
1. First Start-up
Your spa will enter Priming Mode (Pr）when it is energized. During Priming Mode, press "Jets" button (s)
repeatedly and be sure all pumps are free of air. Priming Mode lasts for less than 5 minutes. Press "Warm"
or "Cool" to exit. After Priming Mode, the spa will run in Standard Mode (see Mode section).
The pump responsible for heating and filtration (pump 1 low-speed on non-circ system, or the circ pump on
circ systems) will be referred to simply as the pump. In multi-button sequences, if the buttons are pressed
too quickly in sequence, they may not register.
Pump is the abbreviation of those used for heating and filtering. on operation, if you press too quickly, it
may be unavailable.
2. Temp control (80°F-104°/26.0°-40.0°C)
The last measured water temperature is constantly displayed. The water temperature displayed is
current only when the pump has been running for at least 2 minutes. To display the set temperature, press
"Warm" or "Cool" once. To change the set temperature, press a temperature button again before the display
stops flashing. After three seconds, the display will stop flashing and begin to display the current Spa
temperature.
extend
3. Jets 1: ( key)
This key is without control any function and pump, this key is excrescent or uses it to extend other
function if you need.
4. Jets 2/ Jets 3/Blower（if equipped）
Press the "Jet2" button once, pump 1 would be turn on; Press the "Jet2" button twice, pump2 would
be turn on, pump1 still operated; Press the "Jet2" button thrice, pump 1 would be turn off, pump2 still
operated; Press the "Jet2" button quartic, pump2 would be turn off .
5. Light
Press "Light" to operate the spa light. And off after 4 hours.
6. Time set
When SPA gets through with electricity for the first time," SET TIME" will be shown on control panel.
Press "time" first, then "Mode/Prog" later, press "Warm" or "Cool", when pressing "Warm" or "Cool", time
set will be added or deducted by 1 minute finally, press "time" again to make sure you have set time.
7).Mode
(1) Mode is changed by pressing "Warm" or "Cool", then pressing "Mode" for change.
(2)Standard Mode maintains set temperature, and it will be displayed momentarily when you switch into
Standard Mode.
(3)Economy Mode heats the spa to the set temperature only during filter cycles. Ecn will display when
water temp is not current, and will alternate with water temp when the pump is running.
(4)Sleep Mode heats the spa to within 20℉/ 10℃ of the set temperature only during filter cycles. "SLP" will
display when water temp is not current, and will alternate with water temp when the pump is running.
GS523DZ (for three SPA massage pumps)
- 17 -