Télécharger Imprimer la page

Balboa 908 M3301 Mode D'emploi page 17

Masquer les pouces Voir aussi pour 908 M3301:

Publicité

Les langues disponibles

Les langues disponibles

I、Warning: please read the following instructions before operation, which is a safety guaranty to
SPA users.
1、The system must be installed by qualified technicians, switch for electricity leakage should be installed at the
place convenient to be controlled.
2、The bathtub must be installed to the floor for safety purpose, if not; we won't take responsibility for the lost of the
bad grounding!
3、Taking load capacity of the wires into consideration when installed, otherwise, this will impact normal function or
even occur safety accidents!
4、To ensure sanitation of SPA, those who have skin or infectious disease should not use it.
5、All the jets, fountains cannot be shut down while keep water pumps working simultaneously, for this will damage
the SPA heavily.
6、The first time to use SPA, before filling in water, please check and shut all drain valves, and all the jets, water
pumps must be highly tightened(they might be loose during transportation).
7、The old, kids and those with heart disease and low/high blood pressure should use the SPA cautiously and under
the care of the healthy adults; without doctor's professional instruction, pregnant women cannot use the SPA.
8、Risk:Under the state of alcohol, poison and drugs, it will be dangerous to use the SPA.
9、Make sure that water slips out of jets regularly, or the relative components will be damaged.
10、Protect from getting hurt, please check the water temperature to make sure if it is ok to use when using the SPA.
11、SPA input water temperature should not be over 42 Celsius degrees so as not to get hurt; 30-40 Celsius degree is
the safety scope for human body. When you have been in the SPA for over 10-15 minutes, please try to lower the
water temperature.
12、Before using the SPA drugs, please take the physical property into consideration, for example, granular or root-
like drugs must be walled within filter bag.
13、After finishing strenuous exercises please do not use the SPA right away.
14、If feeling unwell when or after you used the SPA, please stop it right away and go to see the doctor.
15、Do not move or open the lid of filter.
16、Excessive Exposure to the sun for long will damage the SPA surface, when you are not going to use the SPA,
please cover it up against the sunshine.
17、If you use the SPA often, please wash the paper element filter for one time every week.
18、The heat preservation cover is formed of foam, prevent kids playing on it.
19、When filling in water, water should be 1cm over the probe screw when installed China control system, and water
1cm over all the jets when installed Balboa system.
20、No water or water level doesn't reach the probe screw or over all the jets, do not operate the spa.
21、If the spa not to use, please keep the maintenance doors locked well or tighten the screw.
22、All the maintenance must be done after electricity has been cut off.
23、After the repair work and maintenance, check if all the functions run well.
24、In the very cold areas or seasons, please keep the SPA connected with electricity, filled with enough water in the
SPA, so as to protect SPA from being frozen to be broken, or you can drain water completely and cover to seal it.
25、All the preservation and maintenance must be done by qualified professionals. For more service, please contact
the suppliers or sales agents.
26、The product must be permanently connected to the fixed wiring.
27、Parts incorporating electrical components must be located or fixed so that they cannot fall into the bath.
28、The product should be supplied through a residual current device (RCD) having a rated residual operated current
not exceeding 30mA.
29、If your SPA is placed in direct sunlight, as possible as you can, please avoid to place it on the glass floor or near
the location of the glass wall , specular reflection effects can lead too high temperature on partial skirt which will
cause skirt deformation.
- 16 -

Publicité

Chapitres

loading

Ce manuel est également adapté pour:

908 m332908 m351908 m357908 m360