Boiler Descaling Cycle Menu - Gaggia Milano Accademia Mode D'emploi

Masquer les pouces Voir aussi pour Accademia:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BOILER DESCALING CYCLE MENU

Descaling should be performed every 1-2 months or when the machine displays the relevant message. The machine must be on to perform
this cycle; it automatically controls the distribution of the descaling solution.
DO NOT LEAVE THE MACHINE UNATTENDED DURING THIS OPERATION.
WARNING! NEVER USE VINEGAR AS A DESCALING SOLUTION.
Only use the Gaggia descaling solution, especially designed to respect the technical features of the machine, to ensure its performance
will not decrease with time, and for a safe and risk-free use. The descaling solution is to be disposed of according to the manufacturer's
instructions and/or regulations in force in the country of use .
Note: Before starting a descaling cycle make sure that:
1 . THE INTENZA WATER FILTER HAS BEEN REMOVED
2. A container of adequate size or a couple of containers are available and are placed in the points identifi ed
DESCALING AND/OR RINSE CYCLES CANNOT BE STOPPED; ALL THE PHASES MUST BE COMPLETED. IF THE MACHINE IS
SWITCHED OFF OR IN CASE OF POWER FAILURES, THE INTERRUPTED CYCLE MUST BE REPEATED FROM THE BEGINNING.
HOWEVER, CYCLES MAY BE PAUSED BY PRESSING THE "II" BUTTON; IT WILL BE POSSIBLE TO RESUME THE CYCLE AT ANY
TIME BY PRESSING THE ">" BUTTON.
TURN THE SBS DIAL ALL THE WAY TO THE LEFT, COUNTER-CLOCKWISE (SEE PAGE 8), BEFORE STARTING THE CYCLE.
To correctly prepare the descaling solution, pour the entire content of the Gaggia concentrated descaling solution into the water tank, and
then fi ll the tank with fresh water up to the MAX level.
Note: During the descaling cycle, some alarm messages may appear to allow for a correct management of the machine.
After resetting the message, always press the ">" button to resume the descaling cycle.
1
2.5. MAINTENANCE SETTINGS
PRODUCT COUNTERS
DESCALING CYCLE
118(l)
BREW GROUP CLEANING CYCLE
CARAFE WASH CYCLE
CARAFE AUTO CLEAN
ON
Select the menu option .
Press the "OK" button to confi rm.
2
2.5.2. MAINTENANCE SETTINGS
START DESCALING
CYCLE?
Warning: Once this selection is made, the
whole cycle will have to be completed.
Press the "OK" button to confi rm or "ESC"
to exit
3
DESCALING CYCLE
REFILL WATER TANK
WITH DESCALING SOLUTION
Refi ll water tank with descaling solution.
Press the "OK" button to confi rm.
33

Publicité

Chapitres

Table des Matières
loading

Table des Matières