Led Status Display For As Interface; Starting Up; Safety Instructions - Ebro EP 501 B Guide Rapide

Type EP 501 B
10.5 LED status display for AS interface
The LED bus status display indicates the status of the AS interface
(LED green and red).
Bus LED 1, green
Bus LED 2, red
Fig. 16: LED status display for AS interface
Bus LED 1 Bus LED 2
(green) (red)
off off POWER OFF
No data traffic (expired Watch Dog at
off on
slave address does not equal 0)
on off OK
flashing on Slave address equals 0
off flashing Electronics fault of external reset
Timeout bus communication after
flashing flashing
100 ms (peripheral fault)
Tab. 19: LED status display for AS interface
Startingup
11 STARTING UP
11.1 Safety instructions
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
▶ Before starting up, ensure that the operating personnel are
familiar with and completely understand the contents of the
operating instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may start up the equipment/
the device.
english
25