Electrical Installation As Interface; Programming Data - Ebro EP 501 B Guide Rapide

10.4 Electrical installation AS interface
10.4.1 E lectrical connection with circular plug-in
connector M12 x 1, 4-pole
Views of plugs
The views show the image from the front looking at the pins. the solder
connections are behind them.
Pin 4:
NC
Pin 1:
Bus +
Fig. 14: Bus connection without external supply voltage
Pin 4:
24 V +
Pin 1:
Bus +
Fig. 15: Bus connection with external supply voltage (optional)
Bus connection without external / with external supply voltage
24
Pin 3:
Bus –
Pin 2:
NC
Pin 3:
Bus –
Pin 2:
GND
english
Type EP 501 B
Electricalconnection
Pin Designation Configuration
1 Bus + AS Interface bus line +
NC or GND not used or external supply
2
(optional) voltage – (optional)
3 Bus – AS Interface bus line –
NC or 24 V + not used or external supply
4
(optional) voltage + (optional)
Tab. 17: Pin assignment of circular plug-in connector for AS-Interface
When the operating voltage is applied, the positioner is operating.
→
Actuate the automatic adjustment of the positioner, as described
in the chapter entitled "11.2 Specifying the basic settings".
10.4.2 Programming data
Profile version S-7.3.4
I/O con-
7 hex
figuration
ID code 3 hex (analog profile)
Extended F hex (default value, can
ID code 1 be changed by the user)
Extended
4 hex
ID code 2
Profile S-7.3.4
Tab. 18: Programming data
Profile version S-7.A.5
7 hex
A hex
7 hex
5 hex
S-7.A.5