Install And Program The; Security+ 2.0™ Radio Card - CAME FE4024 Instructions D'installation

PROGRAMMING

INSTALL AND PROGRAM THE

SECURITY+ 2.0™ RADIO CARD
1
Install the provided whip antenna to the terminal connection marked with the
antenna symbol (Y with three lines on top).
2
Disconnect all power to the operator.
3
Insert the Security+ 2.0™ radio card into the slot on the electronic card.
4
Connect power.
NOTE: The electronic card picks up the Security+ 2.0™ radio card when the
operator is powered up.
5
Press the button on the Security+ 2.0™ radio card (the LED will light).
6
Activate the display menu by holding the ENTER button for one second.
7
Navigate to USERS > Add User > Choose Confirm? (yes).
8
From the Related Func. menu choose the desired function (2-7, Open,
B1-B2, 2-3P, or Disabled) and then press the ENTER button to make the
selection. The menu will display "Waiting Code".
9
While the "Waiting Code" is displayed, press the Learn button on the radio
card, then press and hold the remote control button. The display will flash the
code and then exit to the Add User menu indicating programming is
complete.
To program additional remote controls press the learn button on the radio card, then
press and hold the remote control button. The radio card will exit programming mode
in 5 seconds.
Electronic Card
ERASE THE SECURITY+ 2.0™ RADIO CARD MEMORY
1
Press and hold the button on the Security+ 2.0™ radio card until the LED
goes out (approximately 6 seconds). The memory is now erased.
INSTALL AND PROGRAM THE SECURITY+ 2.0™ RADIO CARD
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada (IC) licence-exempt RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
This Class B digital apparatus complies with Canadian ICES-003.
23
Display
ENTER Button
Radio Card Slot