IKEA LAGAN Manuel D'utilisation page 23

ENGLISH
Problem and alarm code
The appliance trips the
circuit-breaker.
Refer to "Before first use", "Daily use", or
"Hints and tips" for other possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
The washing and drying results are not satisfactory
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry
water drops on glasses and
dishes.
The dishes are wet.
The interior of the appliance
is wet.
Possible cause and solution
The amperage is insufficient to supply simultaneously all the
•
appliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and basket loading
leaflet.
• Use more intensive washing programmes.
Clean spray arm jets and filter. Refer to "Care and Cleaning".
•
• Tableware has been left for too long inside a closed appliance.
• There is no rinse aid or the dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher level.
• Plastic items may need to be towel dried.
• For the best drying performance activate the dry plus option.
• We recommend to always use rinse aid, even in combination
with multi-tablets.
• The release quantity of rinse aid is too much. Adjust the rinse
aid level to a lower level.
• The quantity of detergent is too much.
The released quantity of rinse aid is not sufficient. Adjust the
•
rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
• For the best drying performance activate the dry plus option.
• The programme does not have a drying phase or has a drying
phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
The quality of the multi-tablets can be the cause. Try a different
•
brand or activate the rinse aid dispenser and use rinse aid and
multi-tablets together.
• This is not a defect of the appliance. it is caused by the humidity
in the air that condenses on the walls.
23