IKEA LAGAN Manuel D'utilisation page 22

ENGLISH
Problem and alarm code
The program does not start.
The appliance does not fill
with water.
The display shows "E1".
The appliance does not reach
the required temperature.
The display shows "E3".
The anti-flood device is on.
The display shows "E4".
The appliance does not drain
the water.
The appliance stops and
starts more times during
operation.
The program lasts too long.
The remaining time in the
display increases and skips
nearly to the end of program
time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds
from inside the appliance.
Possible cause and solution
Make sure that the appliance door is closed.
•
• If the delay start is set, cancel the setting or wait for the end of
the countdown.
• The appliance has started the procedure to recharge the resin
inside the water softener. The duration of the procedure is
approximately 5 minutes.
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
•
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
• Heating element malfunctions. Contact an Authorised Service
Centre.
• Close the water tap and contact an Authorised Service Centre.
Make sure that the sink spigot is not clogged.
•
Make sure that the filter in the outlet hose is not clogged.
•
Make sure that the interior filter system is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
• It is normal. It provides optimal cleaning results and energy
savings.
• If the delayed start option is set, cancel the delay setting or wait
for the end of the countdown.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
Make sure that the spray arms can rotate freely.
•
22