Settings - IKEA LAGAN Manuel D'utilisation

ENGLISH
The dry plus function is not applicable to the
(Rapid wash) programme.

Settings

The water softener
The water softener removes minerals from the
water supply, which would have a detrimental
effect on the washing results and on the
appliance.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
Water hardness
German degrees French degrees
(°dH)
35 - 55
23 - 34
18 - 22
12 - 17
6 - 11
0 - 5
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent or
multi-tabs (with or without salt), set the
proper water hardness level to keep the salt
refill notification active.
Multi-tabs containing salt are not effective
enough to soften hard water.
How to set the water softener level
1. Press the on/off button to switch the
appliance on.
2. Within 60 seconds after the appliance is
switched on, press and hold
than 5 seconds to enter water softener
setting mode.
The water softener should be adjusted
according to the hardness of the water in your
area. Your local water authority can advise you
on the hardness of the water in your area. It
is important to set the right level of the water
softener to assure good washing results.
mmol/l
(°fH)
61 - 98 6.1 - 9.8
41 - 60 4.1 - 6.0
31 - 40 3.1 - 4.0
21 - 30 2.1 - 3.0
10 - 20 1.0 - 2.0
0 - 0.94
0 - 9
3. Press
4. Press the on/off button to confirm the
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. For best drying performance,
always use rinse aid.
The rinse aid is automatically released during
the hot rinse phase.
When rinse aid chamber is empty, the rinse aid
indicator is turned on notifying to refill rinse aid.
for more
Clarke Water softener
degrees level
43 - 69
H6
29 - 42
H5
H4
22 - 28
15 - 21 1)
H3
7 - 14
H2
0 - 6 2)
H1
repeatedly to toggle the following
water softener levels on the display:
H1 - H2 - H3 - H4 - H5 - H6
setting.
13
Salt
consumption
(gram/cycle)
60
30
20
12
9
0