Before First Use - IKEA LAGAN Manuel D'utilisation

ENGLISH
The rinse aid level
It is possible to set the released quantity of rinse
aid between "D1" level (minimum quantity) and
"D5" level (maximum quantity).
How to set the rinse aid level
1. Press the on/off button to switch the
appliance on.

Before first use

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the
appliance. Do not use detergent and do not
load the baskets.
After starting a programme, it may take up
to 5 minutes for the appliance to recharge
the resin in the water softener. It seems
that the appliance is not working.
2. Within 60 seconds after the appliance is
switched on, press and hold
than 5 seconds and then press
rinse aid setting mode.
The rinse aid indicator flashes.
3. Press repeatedly to toggle the following
rinse aid levels on the display:
D1 - D2 - D3 - D4 - D5
The higher the number, the more rinse aid
released by the appliance.
4. Press the on/off button to confirm the
setting.
The washing phase starts only after this
procedure is completed. The procedure is
repeated periodically.
The salt container
Caution! Use rough salt designed for
dishwashers only. Fine salt increases the
risk of corrosion.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
14
for more
to enter