Kärcher Puzzi 8/1 C Consignes De Sécurité page 8

Safety instructions for brush cleaning devices and spray ex-
English
Please read and comply with
these safety instructions prior to
the initial operation of your appliance. Retain
these safety instructions for use for future ref-
erence or for subsequent possessors.
Please read the operating instructions
–
for your machine before using it, and
pay particular attention to the following
safety instructions.
Warning and information plates on the
–
machine provide important directions
for safe operation.
Apart from the notes contained herein
–
the general safety provisions and rules
for the prevention of accidents of the
legislator must be observed.
Power connection
The voltage indicated on the type plate
–
must correspond to the voltage of the
electrical source.
Safety class I - Appliances may only be
–
connected to sockets with proper earthing.
While working with fluids (such as de-
–
tergents), we recommend the use of a
safe socket with overcurrent protection
switch (max. 30 mA).
Please use the mains cable prescribed
–
by the manufacturer; the same is also
applicable when you replace the ca-
bles. See Operating Instructions Manu-
al for Order Number and Type.
Check the power cord with mains plug
–
for damage before every use. If the
power cord is damaged, please arrange
immediately for the exchange by an au-
thorized customer service or a skilled
electrician.
The appliance may only be connected
–
to an electrical supply which has been
installed by an electrician in accordance
with IEC 60364.
Operating procedures create short term
–
power sinkings.
traction devices
During unfavorable net conditions other
–
devices might be disturbed.
With a net impedance lower then 0,15
–
Ohm no disturbances are to be expected.
Never touch the mains plug with wet
–
hands.
Make sure that the power cord or exten-
–
sion cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the cable from heat, oil, and
sharp edges.
The power cord must be checked regu-
–
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must
be replaced before further use.
If couplings of the power cord or exten-
–
sion cable are replace the splash pro-
tection and the mechanical tightness
must be ensured.
Do not clean the appliance with a water
–
hose or high-pressure water jet (danger
of short circuits or other damage).
Appliances with working equipment,spe-
–
cifically the power cord and the extension
cable, must be checked to ensure that it is
in proper working order and is operating
safely prior to use. Otherwise, immediate-
ly pull out the power plug. The appliance
must not be used.
The socket on the device may only be
–
used to connect the attachments and
accessories mentioned in the operating
instructions.
The water level limiter must be cleaned
–
regularly and checked for signs of damage.
The appliance is not a vacuum cleaner!
–
Never suck in more fluid than what has
been sprayed. Do not use to suck in dry
dust!
The appliance is not suitable for vacu-
–
uming dust which endangers health.
Never spray and vacuum up explosive
–
liquids, combustible gases, explosive
dusts as well as undiluted acids and
– 1
✁ ✂
Application