Humidifying Filter / Humidifying Tray - Sharp UA-KIN50E Mode D'emploi

HUMIDIFYING FILTER / HUMIDIFYING TRAY

1.
Remove the
Humidifying Filter
and Tray.
2.
Rinse with plenty of water.
• Do not remove the Float and the
Rollers. If they come off, refer to
below.
3.
Attach the Humidifying Filter
and Tray.
• After maintenance, correctly
reattach the parts.
NOTE How to clean hard to remove dirt.
Kitchen detergent
(only Humidifying tray)
1. Fill the tray half-way with
water.
2. Add a small amount of
1
kitchen detergent.
Soak for
30 minutes.
2
3
Rinse off the kitchen detergent or the descaling solution with clean water.
NOTE
How to install the Float and the Rollers
Float
3. Insert the tab on the
other side of the float
into the hole.
2. Insert the tab of the float
into the hole.
Citric acid
(available at some drugstores)
2 1/2 cups of water
3 teaspoons
1. Insert the Float
under this tab.
Tab
Tab
Float
Float
Cross-Section view
Cross-Section view
EN-15
Tray Panel
Roller
Click
100% bottled lemon juice with
no pulp
3 cups of water
1/4 cup
Soak for 30 minutes.
(When using lemon juice as your
descaling solution, allow for more
soak time.)
Roller
Click
Click
Float