Firewood; Drying And Storing - RAIS Q-Tee II USA Manuel D'utilisation

US English

Firewood

Only burn wood that has been seasoned for at least one full year (two years is better).
If the wood has not been seasoned or dried, energy will be lost in evaporating the wa-
ter held in the wood. Furthermore, condensation or creosote might occur in the stove
and pipe when damp wood is burnt.
Freshly cut wood contains approx. 60-70% water and is completely unsuited for burn-
ing.
Log size should be about 2" (5 cm) less than the width of the firebox
NEVER
BURN TRASH
HARMFUL GASES
-
NON SEASONED WOOD
N
EVER BURN FUELS OTHER THAN SPECIFIED
B
URNING CHARCOAL FOR EXAMPLE
MONOXIDE HAZARDS
All types of wood heat equally per pound; however, the density of wood is not the
same as is shown in the table below, where the combustible value of wood dried for
two years with a moisture of 15-20% is taken into account. See table to the left.
Drying and storage
Wood to be used for burning in a stove should be dried for two years to ensure optimal
burning.
Here are some storage tips:
• Cut and split the wood before storing.
• Keep the woodpile in a dry sunny place, protected from the rain. Do not cover the
pile with plastic, because that prevents the wood from drying properly.
• Stack the wood with enough space between the rows to ensure good air circulation.
• Bring the logs inside the house two-three days prior to use.
Wood type
Beech and oak
Ash
Maple
Birch
Mountain pine
Fir
Poplar
User Manual Q-Tee II USA
(
PLASTIC AND OTHER TYPES OF ARTIFICIAL MATERIALS EMIT
), ,
DRIFTWOOD TREATED OR PAINTED WOOD
.
Dry wood In comparison
kg/m³ to beech
580 100 %
570 98 %
540 93 %
510 88 %
480 83 %
390 67 %
380 65 %
!
,
CONTAINS THE RISK OF GENERATING CARBON
D
O NOT STORE SOLID FUEL WITHIN
SPACE HEATER INSTALLATION
CLEARANCES OR WITHIN THE SPACE
REQUIRED FOR CHARGING AND
ASH REMOVAL
,
ARTIFICIAL LOGS OR
.
17