Orion OREL Notice D'installation Et D'utilisation page 92

7.7- Programming of conflicting command interlocking
This procedure allows to forbid conflicting actions activated by the
simultaneous pressure of two transmitter function buttons.
Relays concerned by the interlocking will be deactivated (OFF state) if an
interlocking is detected..
IMPORTANT :
This programming procedure uses the receiver
/ microswitch.
Every time
circuit
previously programmed interlockings are erased.
„ A transmitter / receiver association must have been realized..
„ This procedure requires transmitter and receiver.
ORRS and ORRA receivers : Switch off the receiver
1
ORRD receiver : the receiver can remain powered up throughout the procedure
ORRS and ORRA receivers : install the jumper
ORRD receiver : set the microswitch
ORRS
2
30 31 32 33 34 35 36 37
V1 V2 V3
JP1
R1 R2
R13 R14
ORRS and ORRA receivers : Switch on the receiver
3
ORRD receiver : go to the next step
4
V2
FR
- 92 -
jumper (ORRS and ORRA) is put in short
microswitch (ORRD) is set on «ON» position,
ORRA
JP2 JP3
R3 R4
R15 R16
ORRA
ORRS ORRD
V3
and LEDs blink 2 times then go off.
EN DE
to the «ON» position
JP1
JP2
V1 V2 V3
to configure the settings.
ORRD
JP1
JP3
Orion - 324501J
jumper
OFF ON
JP2
JP3
JP4
V1 V3 V2